Pottery Banding Wheel Heavy Duty Thrust Ball Bearing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Heavy duty thrust ball bearing to handle the weight of large clay pieces without getting stuck
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 42
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pottery Banding Wheel made with a heavy duty thrust ball bearing to handle the weight of large clay pieces without getting stuck. Uses a thrust ball bearing to handle axial load instead of the usual skate board ball bearings. The banding wheel measures ~6 inches diameter. I have another model for a ~10 inch diameter that the same thrust ball bearing can be switched into.
Needs additional hardware to assemble:
1 x 51120 100mm x 135mm x 25mm thrust ball bearing (Lubricate the bearing with synthetic multipurpose oil for the fastest & smoothest spin speed. Do not use grease as it will lower the spin speed.)
1 x M8 40 mm long bolt
1 x M8 washer
1 x M8 nut
There are 2 3D printed pieces.
Bottom is for the bottom of the banding wheel. It fits the bottom track of the 51120 thrust ball bearing.
Top is the top piece of the banding wheel. It fits the top track of the 51120 thrust ball bearing. The Top piece requires a pause before layer 46 starts to embed the M8 nut.
Both pieces are printed flat against the build plate.
Printer settings:
Strength > Wall loops: 4
Strength > Top surface pattern: Monotonic
Strength > Bottom surface pattern: Concentric
Strength > Sparse infill pattern: Gyroid
Pause before layer 46 for the Top piece that has the M8 embedded nut
I printed using eSun PLA+ in white on a Bambu A1C. It could be printed in PETG, though I haven't tried yet.
See video on how to assemble the banding wheel: https://youtu.be/FUcu3Brapzc