1 / 7
36mL Volume - 3 partition pipetting reservoir for ELISA Assay — zdjęcie 1
1 / 7

36mL Volume - 3 partition pipetting reservoir for ELISA Assay

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 3-partition pipetting reservoir for pH-dependent ELISA washes, 36mL's of total volume.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
8
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This reservoir was designed for pH-dependent ELISA wash steps. It lets you wash all wells in a single top-to-bottom pass with one multichannel pipette, and it holds three different solutions or buffers at once. That makes it useful for any workflow where you need three solutions on hand at the same time.

Print notes: Ours was printed in PETG. I wasn't the one who ran the print, so I can't speak to the exact settings used. We chose PETG because it holds up well with mild saline solutions, which covers most common ELISA wash buffers. If you're printing your own I'd recommend 50% infill or higher to help reduce leaking between compartments. We haven't formally tested it for leaks yet, so keep that in mind.

The design is fully parametric in the included Fusion 360 file, so it's easy to adjust chamber size, wall thickness or tip spacing for your own setup. This model was built with help from Claude and I recommend it for anyone making modifications.

UPDATE 1 - Some happy news! I tested the print by leaving 12 mL of water per partition, and the part didn't leak at all for over 2 hours. We were successfully able to conduct 6 rounds of ELISA washes without any problems, and we loaded the blocking solution from this part after washing the part with ddH₂O between the buffers. Seems like so far so good! 

Tagi