1 / 10
tado V3 / RU01 Adapter Plate for Feller EDIZIOdue — zdjęcie 1
1 / 10

tado V3 / RU01 Adapter Plate for Feller EDIZIOdue

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Centered adapter for mounting the original wired Tado V3/RU01 backplate on a Swiss Feller EDIZIOdue wall box.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
39
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

## tado V3 / RU01 adapter for Feller EDIZIOdue

A one-piece mounting and trim plate for installing the original wired tado V3 / RU01 thermostat backplate on a classic Swiss Feller EDIZIOdue installation while retaining the original Feller metal mounting plate.

The shallow front recess centres the tado backplate automatically. Narrow adjustment slots support small screw heads while allowing alignment, and locally reduced material around the Feller mounting points helps the original screws retain sufficient reach. Once the original tado backplate is secured, the thermostat clips onto it normally.

## Compatibility

- Original wired tado V3 / RU01 backplate

- Classic Feller EDIZIOdue installation with the 77 x 77 mm metal mounting plate

- 56 x 56 mm Feller screw pattern

Please compare the dimensions and mounting arrangement with your installation before printing. Feller and tado have produced different generations and variants.

## Recommended print settings

- Material: PLA tested; PETG is also suitable

- Layer height: 0.20 mm

- Perimeters: 4 or more

- Top and bottom layers: 5 or more

- Infill: 25-40%

- Use monotonic top infill; ironing is optional for the visible surface

White filament matches typical white Feller installations well.

## Installation

1. Switch off the mains supply and verify that the circuit is de-energised.

2. Keep the original Feller metal mounting plate installed.

3. Position this adapter and fasten it through the narrow Feller adjustment slots.

4. Place the original tado backplate into the shallow centring recess.

5. Secure it through its original internal mounting slots using suitable short screws.

6. Connect the wiring according to the official tado documentation and clip the thermostat onto its original backplate.

Electrical installation must comply with local regulations and should be carried out or checked by a qualified electrician.

## Included files

- 3MF for printing

- STL mesh

- STEP source for adaptation

This is an independently designed community accessory and is not affiliated with or endorsed by tado GmbH or Feller AG.

Tagi