Air Latschen V3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
(Prototyp / Test Version)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 204
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
The Air Latschen V3 is the third iteration of an experimental, 3D-printable one-piece flip-flop / slide concept designed for flexible filaments.
⚠ IMPORTANT DISCLAIMER: UNTESTED PROTOTYPE ⚠
This model is purely an experimental design study and prototype.
It has not been tested for durability, safety, structural integrity, or long-term comfort.
Printing and wearing this model is entirely at your own risk.
NO COMMERCIAL USE / NO SALES ALLOWED: You are not permitted to sell the digital files, remixes, or physical 3D prints made from this model.
📐 Sizing & Slicing Guide (Measure Before You Slice!)
To ensure a proper fit, scale the model in your slicer before printing:
Measure Your Foot:
Place your foot flat on a piece of paper and mark the back of your heel and the tip of your longest toe.
Measure the distance between the two marks in millimeters (mm).
Important: Add 10–15 mm of extra clearance so your toes and heel don't sit directly on the raised edges.
Scale in Slicer (PrusaSlicer, Bambu Studio, OrcaSlicer, Cura, etc.):
Import the STL.
Ensure Uniform Scaling (proportional scaling) is enabled.
Set the overall length (usually the X or Y axis depending on orientation) to your measured foot length + clearance. The width and strap height will scale automatically.
Mirror for a Full Pair:
Duplicate the scaled model and use the Mirror tool along the appropriate axis to generate the opposite foot (left/right).
🖨 Recommended Print Settings (Experimental)
Material: TPU only (e.g., Shore 90A, 95A, or softer). Do NOT print this in rigid filaments (PLA, PETG, ABS) — the strap will not flex and will break immediately.
Orientation: Print flat on the bottom sole.
Supports: Required under the floating strap and bridge areas. Tree / Organic Supports with snug interface spacing are highly recommended for easier removal.
Infill: 15%–25% (Gyroid recommended) for a balance between stability and cushioning.
Walls / Perimeters: 3–4 perimeters to provide strength to the strap structure.