Housing for ESP32 C3 with built-in OLED Display
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A housing or case for the popular esp32 variant that has a built-in OLED. Print in place without supports.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 153
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A housing for ESP32 C3 with built-in OLED
Perfect for projects like Temperature/hunidity sensors, or anything else with a small display
Features
Three variants, one with no buttons, one with both buttons, and one with only the programmable Boot-button and a hole for the reset button.
No assembly hardware required
The board installs with a snap, stays firmly in place, and can be easily removed.
Instructions
Tolerances are quite small, make sure you don't over-extrude and make sure you have good bed adhesion for the first layer
PLA works fine
To install the board, put the USB-C port through its hole first, then gently press down on the rear end of the board until it snaps in place
To remove the board, pull on the back wall of the housing until the board comes free and push gently in the display.
The device is very inexpensive, and can be found in misc stores, like here for example: https://www.aliexpress.com/item/1005007856887996.html
