Schumacher KC Ball Diff Seal
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A diff seal for the ball diff in the Schumacher KC. I found that in the summer a lot of dirt/sand/dust was getting…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 162
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
A diff seal for the ball diff in the Schumacher KC. I found that in the summer a lot of dirt/sand/dust was getting inside the diff and causing less than normal operating times, so designed a simple seal to stop this. It comes in two parts, the most effective one is the inner seal but the outer one helps a little too.
Tested it most of the summer, as well quite a few of my fellow Schumacher drivers, and everyone found it very useful. It just slides one over the outdrives and sits inplace nicely.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
High
Notes:
ABS or PETG required due to the heat that may build up. High infill required to make it as strong as possible, but also use high wall thickness too (Infill may not actually be used anyway)rnrnSupports required for the outer seal but not required for the inner
Category: R/C Vehicles