Height adjustable feet for IKEA LACK table
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
More visually appealing variant of height-adjustable feet for the IKEA LACK table instead of my first attempt.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 70
- Wydruki
- 2
- Wyświetlenia
- 560
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I was not satisfied with my first design of the height-adjustable feet (model:182488). Technically they work fine, but optically it looks strange.
I also wanted to put the table on wheels, which wasn't possible with the existing feet. New feet had to be added. They should have a square base to which one can attach wheels, but still be height adjustable. This is how the current model came into being.
As with my version 2 of the first design, the legs must be completely hollowed out at the bottom. This is in most cases relatively simple, but sometimes there is a more stable version of a block at the leg end, which then requires a little more work.
Common Printer Settings:
Material: PLA
Resolution: 0.2mm
Wall thickness: 1.2mm
Infill: 20%-50%
Flange
This part is inserted into the table legs. If you like, you can glue them in, but I didn't do that.
Additional parts:
none
Printer Settings:
Infill: 30%
Support: yes
Adhesion: Skirt
HolderPlate
This plate secures the adjusting wheel to the flange. I used self-tapping screws for screwing, because they hold well in the plastic and are easier to use than screws and nuts.
Additional parts:
4 x sheet metal screw 2.9 x 9.5 or 2.9 x 13
Printer Settings:
Infill: 20-30%
Support: no
Adhesion: none
Slider and Wheel
These two elements form the actual height adjustment. Here I used a metric fine thread M36 x 3. This looks a lot better than my first edition of the height-adjustable feet.
The tolerances are relatively tight, but at the end there is an almost play-free fit. The first screwing together requires a certain amount of force until the unevenness of the printing has rubbed off each other. This is especially the case with a resolution of 0.2mm. A resolution of 0.1mm would be possible, but takes a very long time to print.
Finally, I screwed wheels with a hole distance of 29mm to the slider. But you can also do without it, but to protect a wooden floor you should glue felt pieces on it.
Additional parts (only with additional wheels):
4 x sheet metal screw 2.9 x 9.5 or 2.9 x 13
Printer Settings:
Infill: 30-50%
Support: no
Adhesion: Skirt
Category: 3D Printer Accessories