1 / 1
Full Radxa Penta SATA HAT NAS Case compatible for HDD (not SSD) and OEM Oled frame fix. — zdjęcie 1

Full Radxa Penta SATA HAT NAS Case compatible for HDD (not SSD) and OEM Oled frame fix.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix from initial design of GrabCad (https://grabcad.com/library/radxa-penta-sata-hat-nas-case-1)

Ocena
0 / 5
Polubienia
2
Pobrania
17
Wydruki
0
Wyświetlenia
153
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

Starting from the initial model downloaded from GrabCad, I made a modification to the hard drive divider by adding a grid for better cooling (GridGuideHDD.step) and the top cover with a cutout for a centered OLED screen (TopCoverRadxaV2.step) so that it is compatible with the OLED module provided by Amazon (https://www.amazon.fr/dp/B07JN2NK3F?ref=ppx_yo2ov_dt_b_fed_asin_title).

For those experiencing OLED screen failure on the SATA HAT Top Board (https://radxa.com/products/accessories/penta-sata-top-board/) and who wish to use the model sold by Amazon.

Here are the steps to follow:

-1- Completely desolder the ribbon cable of the faulty OLED, taking care not to leave a short circuit between the PCB traces.

-2- Desolder the resistors marked with the two red crosses in the bottom photo.

-3- Use four 3cm wires with a cross-section of less than 0.2mm² to interconnect the Amazon OLED module to the RADXA board as shown in the photo.

-4- Apply insulating tape or Kapton tape to the back of the Amazon OLED module.

-5- Carefully clip the OLED module into the bottom of the "TopCoverRadxaV2" cover, then place the RADXA board on top, securing it with the four screws.

If you encounter display problems, I can provide you with my Python code, which will allow you to identify the correct driver for the Amazon OLED.

Enjoy printing !

Tagi