1 / 1
Full Radxa Penta SATA HAT NAS Case compatible for HDD (not SSD) and OEM Oled frame fix. — image 1

Full Radxa Penta SATA HAT NAS Case compatible for HDD (not SSD) and OEM Oled frame fix.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix from initial design of GrabCad (https://grabcad.com/library/radxa-penta-sata-hat-nas-case-1)

Rating
0 / 5
Likes
2
Downloads
17
Makes
0
Views
153
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

Starting from the initial model downloaded from GrabCad, I made a modification to the hard drive divider by adding a grid for better cooling (GridGuideHDD.step) and the top cover with a cutout for a centered OLED screen (TopCoverRadxaV2.step) so that it is compatible with the OLED module provided by Amazon (https://www.amazon.fr/dp/B07JN2NK3F?ref=ppx_yo2ov_dt_b_fed_asin_title).

For those experiencing OLED screen failure on the SATA HAT Top Board (https://radxa.com/products/accessories/penta-sata-top-board/) and who wish to use the model sold by Amazon.

Here are the steps to follow:

-1- Completely desolder the ribbon cable of the faulty OLED, taking care not to leave a short circuit between the PCB traces.

-2- Desolder the resistors marked with the two red crosses in the bottom photo.

-3- Use four 3cm wires with a cross-section of less than 0.2mm² to interconnect the Amazon OLED module to the RADXA board as shown in the photo.

-4- Apply insulating tape or Kapton tape to the back of the Amazon OLED module.

-5- Carefully clip the OLED module into the bottom of the "TopCoverRadxaV2" cover, then place the RADXA board on top, securing it with the four screws.

If you encounter display problems, I can provide you with my Python code, which will allow you to identify the correct driver for the Amazon OLED.

Enjoy printing !

Tags