Core One Indx right filament sensor alternate mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mounts the filament sensor where the PTFE-holder-right would normally go.
- Ocena
- 4,75 / 5
- Polubienia
- 14
- Pobrania
- 66
- Wydruki
- 6
- Wyświetlenia
- 608
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Open Community License v1.1
This is a replacement of the PTFE-holder-right and INDX-C1-FS-holder to mount the filament sensor on the upper right side where it is more convenient for certain dry box setups.
It mounts with the existing screws used for the holder right and the screws to mount the filament sensor to the FS-holder.
This should work well with https://www.printables.com/model/1774352-indx-filament-sensor-bowden-adapter-ecas04-pc4-m10/files to add Bowden adapters. See that model for how it mounts on the filament sensor.
I printed this with PETG, with supports and oriented the model with the base down (with the writing on it). Note that the two screw holes do require a little work to remove the supports.
Note that the tools are sensitive to the length of the pfte tubes. I shortened mine by the lengths specified in the assembly guide between the right holder and the filament sensor (each one varies by 30 mm) See https://help.prusa3d.com/guide/4-indx-toolhead-side-filament-sensors_1096247#1103839
A remix was done for the left hand side pfte holder as well.