ryobi battery to 5 cell 18650 charger conversion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Takes a spare ryobi 1.5AH battery and turns it into a 5 cell 18650 charger when plugged into a ryobi charger.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 227
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Take a spare 1.5ah ryobi battery and convert it into a fast charging 5 cell 18650 charger. must be wired in series with the balance charging wires to their proper bridges etc etc, but this is a case that makes that much more simple. All 5 battery trays would need to be occupied by discharged cells, this would not charge individual single cells one at a time. I used 0.035 mig wire for all the positive terminals and 0.065 iron tig rod for all the negatives. 18 guage wire or smaller for connecting to the board, probably best to solder wires to the board first, install the board to the charger base and then cover with the battery tray to solder the wires to their respective locations after wards. Take care not to mix up their locations. These mig and tig wire combinations hold the battery in well enough to not fall out when upside down but not enough to need to be forced in or out excessively. You will need to make jumper wires from a normally open momentary switch to pins Vss and Rst on the battery control board, this facilitates dropping the error cache files created when the original batteries are removed from their control board which stops this charger from being recognized as ready to start charging, (see photos). After every time you reload different batteries you will need to reset the error cache with said button before sticking the adapter into a ryobi charging base. Also, I have noticed that I have to use a bit of cardboard to space the stem to the one rounded side of the stem to make it contact all the pins... so this base file isnt perfect. If someone cared they could thicken the one side of the stem to mitigate the need for cardboard spacing... ill stick with my cardboard for now personally.