Dometic Seitz S3 S4 Window Opener Click Clack Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A common problem with this model of the Dometic / Seitz S3 / S4 windows is, that you lose the clips for the spring +…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 1712
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A common problem with this model of the Dometic / Seitz S3 / S4 windows is, that you lose the clips for the spring + steel ball when you don't notice it.
I designed this replacement clip that can and should be secured with a cable tie. The cable tie can be applied as shown on the picture or all the way around the clip, if you have enough space.
I used a 4mm steel ball from a dissembled 608 bearing and a ball pen spring to replace the metal parts.
There is no way I will lose this setup again. I wish the spring was harder / stiffer but for now it holds the window open if there is no wind.
This is my own technical design to repair and improve the mentioned product. I did not copy any manufacturers design nor am I in contact or representing a manufacturer.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Clone
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
100%
Filament: Redline PETG
Notes:
Print flat, so that the overhang is supported. Small bridges don't need support. Use 4-6 perimiters and / or 100% infill.
I printed in a PETG Filament that I don't like anymore. The design still holds strong (due to the zip tie) but it deformed heavily because of permanent sun and heat. Maybe other PETG products are better than mine or just use a more temperature resistant filament. If course it is fine for a quick repair for the next trip but I'm looking forward to replace them with ASA, PCTG or PC parts.
Category: Automotive