Quadcopter Landing Gear (also some motor soft mounting)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this object because I had problems with the props hitting the ground at takeoff, since a under sling…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 172
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I designed this object because I had problems with the props hitting the ground at takeoff, since a under sling battery. The object also might help to reduce some vibrations.
It will lift the end of your quad arms by 12mm, which is 2mm more than most neoprene/3m pads. Make sure to not tighten the motor screws too hard.
My succession is, to print this in TPU to not destroy it on a hard landing.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20% honeycomb
Notes:
Printed in Semiflex, infill was chosen, so that there is some kind of additional support within the landing pads. Depending on your slicer, this may vary.
Category: R/C Vehicles