Quadcopter Landing Gear (also some motor soft mounting)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed this object because I had problems with the props hitting the ground at takeoff, since a under sling…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 28
- Makes
- 0
- Views
- 172
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
I designed this object because I had problems with the props hitting the ground at takeoff, since a under sling battery. The object also might help to reduce some vibrations.
It will lift the end of your quad arms by 12mm, which is 2mm more than most neoprene/3m pads. Make sure to not tighten the motor screws too hard.
My succession is, to print this in TPU to not destroy it on a hard landing.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20% honeycomb
Notes:
Printed in Semiflex, infill was chosen, so that there is some kind of additional support within the landing pads. Depending on your slicer, this may vary.
Category: R/C Vehicles