AM5 CPU cooler mount for the BC250
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An AM4/AM5 CPU cooler mount for the BC250
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 214
- Wydruki
- 1
- Wyświetlenia
- 1309
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a CPU cooler mount for the BC250 board. It takes AM4/AM5 brackets.
There are 7 variants to choose from, depending on the height of the washers that are supplied with your cooler : from 6.5 to the original 9mm, from which I started the remix. Measure your washers, and remove 4mm to pick your model.
For example, JiuShark JF13K and Thermalright AXP120-X67 are both supplied with 10.8mm washers for their AM5 brackets => the 6.75mm version is recommended.
This mount requires 4 times M4 x 6mm(D) x 4mm(L) heated inserts for outer holes, plus 4 times M3 x 5mm(D) x 4mm(L) for inner holes. This allows to swap coolers and brackets without removing the adapter from the bc250. If you can't install or source these inserts, I've been reported you can however still use M3 screws and nuts, if that helps.
To be printed with some heat resistant filament such as ASA, ABS, HT-PLA...
Remixed from : https://makerworld.com/fr/models/2596083-bc-250-am4-5-cpu-cooler-mount
01-10-2026 : added multiple height options (from 6.5mm to 9mm every 0.5mm), plus changed the inner hole heated inserts from M4 to M3 to increase bracket compatibility
27-09-2026 : added a 6.75mm for to try with the JF13K when installed in vertical position, providing additional contact pressure to compensate for the weight of this mammoth cooler.