EcoBooster and other accessory holder for Kärcher (K5 tested, may fit other models too)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part extends the storage capacity of a Kärcher pressure washer, providing space for 1 additional lance.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
Many Kärcher pressure washers do not provide enough space to carry accessories, such as an additional lance (their "EcoBooster" is an example). Since most parts of the surface of their pressure washers are curved, attaching an accessory is not easy.
This part is a simple, open bracket that attaches to the front of the original, factory-provided holder:
The bottom of the accessory lance still sits "in" the original receiver, as intended:
A design challenge was the space: The hooks that attach to the original holder need to be big enough to secure the part in place, and still leave enough space between them so that the original storage space is almost not impacted.
Printed in black Prusament ASA, 0.2 mm layer height and attached to the original holder with HotGlue.
Successfully tested on the Kärcher K5 that is visible in the photos. The unit may of course fit other models, too (if you have other uses => please leave a comment ☺)
Enjoy 😀 and if you made it, please post a “make” and leave a “like” 😋
Full disclaimer: OpenSCAD coding was assisted by ChatGPT.