1 / 3
WLED Water Lamp Stand (ESP8266 & WS2812B 8x8 Matrix) — zdjęcie 1
1 / 3

WLED Water Lamp Stand (ESP8266 & WS2812B 8x8 Matrix)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Compact base for ESP8266 and 8x8 WS2812B matrix running WLED. Turn any textured glass vase into a mood night light.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
33
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A minimalist standalone lamp base designed to transform a standard textured glass vase filled with water into an ambient, diffused mood lamp or night light.

The enclosure houses an ESP8266 (D1 Mini / ESP-12) development board and an 8×8 WS2812B RGB LED matrix (64 LEDs) controlled via the popular WLED open-source firmware. Placing a patterned glass vase with water on top creates dynamic, organic light refraction patterns across the room.

Dimensions & Compatibility:

  • Base Diameter: 100 mm (fits vases with a base diameter up to ~100 mm)

  • LED Pocket: Sized specifically for standard WS2812B 8×8 square matrix modules

Electronics & Components:

  • Controller: ESP8266 (e.g., D1 Mini form-factor) flashed with WLED

  • LEDs: WS2812B 8×8 (64 LED) square matrix panel

  • Power: 5V USB power supply / cable

  • Diffuser / Shade: Any patterned or textured glass vase with a base diameter ≤100 mm (add water for maximum dispersion)

Assembly & Wiring:

  1. Solder 5V, GND, and Data In lines from the ESP8266 (typically GPIO2/D4) to the WS2812B matrix.

  2. Route the USB power cable through the integrated side cutout.

  3. Fit the ESP8266 board into the lower internal cavity.

  4. Press-fit or adhere the LED matrix flush into the top square pocket.

Print Settings:

  • Material: PLA or PETG 

  • Layer Height: 0.20 mm

  • Infill: 15–20% (Grid / Gyroid)

  • Perimeters/Walls: 2–3

  • Supports: No supports needed (prints flat on the bed)

Tagi