1 / 2
Dometic FJX7 Aircon Remote Holster — VHB Tape Mount — zdjęcie 1
1 / 2

Dometic FJX7 Aircon Remote Holster — VHB Tape Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wall-mount holster for the Dometic FJX7 aircon remote. Moulded pocket, one-hand draw, recessed 19mm tape channel.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
21
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

The FJX7 is a cracking bit of kit, but the remote holder it ships with is nasty imo and rattles. It's the only way to control the aircon, and it spends its life migrating between the worktop, the bed and the floor of the van — usually turning up somewhere at 3am when the fan's stuck on full. Nothing exists for this handset, so here's one, traced from the remote itself.

What you get:

  • Moulded pocket. The cavity follows the handset's actual cross-section, not a box around it. [0.5]mm clearance per side gives a light friction fit — held with barely any wobble, still draws out one-handed. Nothing rattles down a B-road.

  • Open front.

  • Recessed tape channel. The flat back pad has a 20mm-wide, 0.6mm-deep channel that locates a strip of 19mm VHB tape and hides its edge. Fits 1mm-thick foam tap

Compatibility: designed around the remote supplied with the Dometic FJX7 rooftop aircon.

Printing: [no supports, prints flat stood upright. PETG or ASA recommended for temps. 

Bonus for the Home Assistant crowd: if you'd rather not touch the remote at all, I reverse-engineered the FJX7's BLE protocol and wrote an ESPHome integration — github.com/prebsit/dometic-fjx7-ha

Tagi