Bag Hook for a Desk Edge or a Chair Back
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clamps onto a table edge, a desk lip or a chair backrest and gets the backpack off the floor.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Clamps onto the edge of a table, a desk or a chair backrest and holds a backpack, so the bag stops living on the floor where everyone kicks it. One printed part. No screws, no glue, no supports.
Which file to print
Three jaw sizes are included, and each has a sprung tongue inside that takes up the slack below its full opening.
chair_bag_hook_20mm.stl — jaw 20 mm, grips tops 10–20 mm
chair_bag_hook_25mm.stl — jaw 25 mm, grips tops 12–25 mm
chair_bag_hook.stl — jaw 30 mm, grips tops 16–30 mm
Measure your table top or backrest with a ruler and pick the size whose range contains it. A 3 cm table top is the 30 mm file, which is the one in the photos. If your thickness falls in an overlap, take the smaller jaw — it is the tighter, quieter fit.
Print the coupon first
Every size ships a fit test file: a 13 mm-wide slice of the jaw only, about seven minutes and a couple of grams. Clip it on your own table and check the grip before committing to the full hook. Jaw depth and tongue grip are the only two things that can be wrong, and the only two a picture cannot tell you.
It is parametric, and the source is in the download
The .scad is included, so you are not stuck with three sizes. Change rail_t to your thickness and export.
One rule comes with that. Tongue travel is rail_t - rail_min, and that travel is what bends the tongue, so widening the jaw means raising rail_min with it. The file checks this for you and refuses to render if the tongue would be over-stressed, echoing the number it worked out so you can see the headroom. The three shipped sizes sit at 28, 36 and 39 MPa against a 40 MPa working ceiling. Hook cup, leg lengths and width are tunable the same way.
How it holds on
The bag hangs off the outside, so its weight tries to tip the hook backwards off the edge. The long leg stops that by bearing flat on the surface. That is why one leg is much longer than the other, and why the jaw does not have to squeeze hard: the load tightens it for you.
On a table the long leg goes on top, so you want:
about 42 mm of clear table top
about 26 mm of clear underside near the lip
no drawer and no apron right at the edge
The cup will not let go
18 mm wide, 24 mm deep, and the last 7 mm of the tip leans back toward the leg so the rim is only 14 mm. A padded strap, a tote handle or a lanyard drops in from above but cannot walk up and out when the bag swings.
Printing
Print exactly as oriented, lying on its side. Every wall is then vertical, so it needs no supports, and the bending load runs along the layers instead of across them, which is far stronger.
0.2 mm layers, 3 walls, 20 % infill
about 13 g
PLA is fine
PETG if your edge is at the thick end of the range and the tongue will sit squashed for months — PLA creeps under a sustained bend and the grip slackens. The hook still holds; it just rattles.
