SKÅDIS mount for X56 Hotas

Logitech X56 HOTAS SKÅDIS Wall Mount

A simple wall-mounting bracket for the Logitech X56 HOTAS throttle and joystick, designed to mount directly to an IKEA SKÅDIS pegboard.

The same mount works with either the X56 throttle or joystick, so if you want to mount both, simply print two mounts.

Features

• Supports the full weight of the X56 unit

• Uses the existing screw holes in the X56, so no modification to the HOTAS is required

• Allows the throttle/joystick to remain fully assembled

• Quick to remove — simply undo the mounting bolts

• Designed for use with the SKÅDIS T-Clip system

• Tested using PETG

• Supports can be used around the countersunk bolt holes, although they may not be strictly necessary

What you need

For each mount:

• 2 × bolts, approximately 60–70 mm long

• 3 × SKÅDIS T-Clips

The mount was designed around the excellent SKÅDIS T-Clip system, available here:

SKÅDIS T-Clip System

Personally, I prefer to use the Mini T-Clips with this mount, as they provide a slightly neater solution:

SKÅDIS T-Clip Mini – Parametric

Both versions should work with the mount.

If mounting both the X56 throttle and joystick, print 2 mounts and double the required hardware.

Printing

I printed the mount in PETG. The model can be printed without extensive support; supports around the countersunk bolt holes are recommended for the cleanest result, but you may find they aren't necessary depending on your printer and settings.

The result is a convenient way of getting the X56 off the desk while keeping the controls ready to use and easily removable when required.