DIY PET Bottle Ant Farm - Educational Formicarium (Upcycled)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Turn a 2L PET bottle into a 360° educational ant farm. 100% 3D printable, no supports needed, ideal STEM project!
- Ocena
- 0 / 5
- Polubienia
- 348
- Pobrania
- 529
- Wydruki
- 0
- Wyświetlenia
- 6072
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Chemistry & Biology
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
🐜 Upcycled PET Bottle Formicarium Core
Turn a standard 2L soda PET bottle into an interactive, professional-looking Ant Farm (Formicarium)!
This 3D-printed nest insert is designed to fit inside a cut 2L Coca-Cola PET bottle, transforming household plastic waste into a full 360-degree observation nest for science projects, classrooms, and antkeeping enthusiasts.
🌟 Key Features
* 360° Observation Tunnels: High-visibility outer chambers designed for easy observation of ant behavior, queen activity, and tunnel dynamics.
* Integrated Hydration System: Central top port accepts a cotton or sponge plug to regulate humidity easily using a dropper or pipette.
* 100% Support-Free: Optimized geometry for easy printing without any support structures.
* Eco-Friendly STEM Project: A great hands-on activity for kids, families, and science fairs to learn about biology and recycling.
🛠 Assembly Instructions
1. Prepare the Bottle: Take a clean, dry 2L PET bottle (designed around a standard 2L Coca-Cola bottle) and carefully cut off the bottom section at the designated height using scissors.
2. Insert the Core: Insert the 3D-printed nest core from the bottom.
3. Hydration Setup: Place a small piece of cotton or sponge into the top center hydration port.
4. Ventilation: Use a small pin or needle to poke tiny air ventilation holes in the bottle cap.
> ⚠ Tolerance & Scaling Note:
> Bottle wall thicknesses and PLA/PETG shrinkage can vary slightly. If the fit feels too loose or too tight on your specific bottle, try scaling the model by 99% to 101% in your slicer.
🎥 Video Assembly Guide & Project Story
Check out the full video showing the assembly and test with my 3-year-old daughter on YouTube:
Designed with Autodesk Inventor.
