Quick Print Makita DC18RC Charger Ikea Skadis Pegboard holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A strong but quick to print holder for the Makita 18V Charger.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Notes:
Due to the asymmetric position of the feet, you need to print the "holder-right" with a small support on the peg that's otherwise in the air.
Paint-on supports work best so you don't get support meterial inside the hollow pegs.
PLA is fine.
This print orientation is the strongest option. Don't worry of you get small lengthwise cracks in the hollow pegs where the material is thin, it won't really affect strength.
Use at least 4 perimeters (with 0.4 mm nozzle).
Pull out the rubber feet from the charger and undo the screws. Insert the part and re-fasten the screws.