Custom Enclosure for JX-Y36 Bluetooth Audio Amplifier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for JX-Y36 200W Bluetooth 5.0 Amplifier (2x100W USB FM). 100% supportless, OpenSCAD included.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 50
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A fully supportless, parametric enclosure designed for the popular JX-Y36 Bluetooth audio receiver and amplifier board (130 x 43 mm front panel).
This housing is engineered for maximum functionality, durability, and print efficiency. It features built-in elevated feet, 360-degree ventilation, and clever self-aligning internal mounting ears.
⚠ Important Assembly Tip (Factory Screws Modification)
Note: The stock factory screws that attach the PCB to the module's front faceplate come with an integrated large washer/flange. This washer collides with the inner wall of the 3D-printed enclosure.
Quick Fix:
Mark where the wide screw washer collides with the inner wall.
Unscrew the factory screw.
Trim / clip off the colliding edge of the washer using flush cutters or wire cutters.
Re-install the screw and slide the board smoothly into the housing.
Key Features
100% Support-Free Design
Integrated 3mm Airflow Feet
Thermal Ventilation
Fully Parametric OpenSCAD Source Included: Easily adjust dimensions, hole sizes, wall thickness, or vent spacing if needed.
Specifications
Outer Dimensions: 131 mm (W) x 44 mm (H) x 60 mm (D)
Wall Thickness: 2.0 mm
Mounting Hole Distance: 119 mm (compatible with M2 self-tapping or machine screws)
Recommended Print Settings
Print Orientation: Place flat on the rear face
Supports: NONE (all overhangs, ramps, and feet are 45° self-supporting).
Layer Height: 0.20 mm (or 0.28 mm for fast drafts).
Infill: 15–20% (Grid, Gyroid, or Rectilinear).
Perimeters/Walls: 3 walls for extra strength around screw holes.
Material: PLA, PETG (PETG recommended if the amplifier board runs hot).
Assembly Instructions
Print the enclosure on its back panel.
Route your power supply wires, speaker leads, and external antenna wire through the rear "Thor's Hammer" cable slot.
Connect the wiring to your JX-Y36 module.
Trim the factory screw washers as described in the tip above if they collide with the inner side walls.
Slide the module into the front opening until the mounting ears align with the board's screw holes.
Secure the module using two M2 screws.
Files Included
.stl– Ready-to-print enclosure model..scad– OpenSCAD source file for custom modifications.
If you like this design, please post a Make and leave a rating! Happy printing!