Mini Hook For Inside Cabinets or Cupboards
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This small hook only requires one fastener and is intended for light duty loads.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This little hook was designed to hold our over-the-sink drying rack - used two of them. Simple design with one fastener required. Could be use for drying pads with hanging loops or whatever you think of.
3/8" wide. Just under an inch tall. An inch depth overall, and 3/4" depth to hang stuff on.
It's a quick and simple print if printed laying on its side.
I used PLA, with 100% infill since the whole thing is only 1/8" thick. Surprisingly sturdy for it's size, but not intended for heavy loads of course.
#6 screw fits fine through the fastening hole.
Didn't set this up fully parametric but link to Onshape file is below if you want to mess with it.