Mini Hook For Inside Cabinets or Cupboards
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This small hook only requires one fastener and is intended for light duty loads.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
This little hook was designed to hold our over-the-sink drying rack - used two of them. Simple design with one fastener required. Could be use for drying pads with hanging loops or whatever you think of.
3/8" wide. Just under an inch tall. An inch depth overall, and 3/4" depth to hang stuff on.
It's a quick and simple print if printed laying on its side.
I used PLA, with 100% infill since the whole thing is only 1/8" thick. Surprisingly sturdy for it's size, but not intended for heavy loads of course.
#6 screw fits fine through the fastening hole.
Didn't set this up fully parametric but link to Onshape file is below if you want to mess with it.