MASS NAS side panel for top/bottom
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a side panel that fits into the top/bottom panels, which means that it is smaller than the normal side panels.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 58
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I just wanted a minimal case for my ITX motherboard, and I've previously used the MASS MODCASE, however, I wanted it to just be quite barebones, so no bays, no top, etc.
So instead I've made this sidepanel, which can just fit on the top/bottom into the holes where there are support for clips.
This needs to be printed like the other things that has a MESH. I don't know how I can name things on export from FreeCAD, but it should be fairly simple to figure out which part is the mesh.