1 / 2
Prusa MMU2 thumbscrews for idler tensioning.
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My MMU is in a pretty tight location and I can't easily get an allen key in there to adjust the idler tension.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 463
- Wydruki
- 6
- Wyświetlenia
- 2903
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 6) (Komentarze: 14)Remiksy (2)Kolekcje (154)Powiązane
My MMU is in a pretty tight location and I can't easily get an allen key in there to adjust the idler tension. Here is a design for some thumbscrews that can be pushed onto 40mm M3 screws to adjust the tension without an allen key. They are a friction fit on the screws and will probably need to be tapped into place. There's a small step halfway along the cylinder to show about where "flush" would be with the original screws.
Can be printed big end down, without support.