DMD Remote 2 angled bar mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An angled bar mount for the DMD Remote 2
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 280
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this bar mount to fit the DMD Remote 2 to my KTM 390 Adventure R. The angle and spacing is adjusted to fit around the mirror mount and clutch assembly on my bike but it might fit other bikes as well.
The design uses two M4x25 screws and nuts to secure the clamp. For proper hold on the clamp some sort of rubber insert or tape will be required. I used a piece of double sided rubber tape and that seems to be holding up nicely.
I haven't been able to test the durability properly but printed in PETG with strong settings seems to be sturdy enough. I've attached a picture of the print orientation I used, which ensures that the layer lines are optimal for the stress in the bar clamp.
I also made an alternate version of the bracket where I've cut an angle on the semicircle where the remote mounts so that the piece might be printed without supports. I haven't tested it but I don't think it should have an impact on the functionality.