Flat-Top Monster — Halloween Figure, 57 mm, No Supports

A scowling flat-top monster with a stitched brow, fists up, printed in one piece.

Heavy jaw, underbite, pointed ears, and a flat cranium with a row of stitches across it. At 60 %

scale it is 60.0 × 53.4 × 57.0 mm and about 37 g of PLA.

The photos are a real print of this file at 60 % scale, orange PLA, unpainted.

What is measured, not guessed

- Solid — 382.5 cm³ in the file, 45 % of its bounding box.

- Watertight — zero open edges, one connected solid, 199 974 triangles. Three non-manifold edges

left over from decimation; slicers merge them silently.

- No supports. 15.0 % of the surface past 45°. The largest flat ceiling is 0.76 cm², 27.6 mm across

— the underside of the brow ridge over the eyes, 13.4 mm up in the file. It is a short bridge over

a recess and it comes out clean.

- Flat base 600 mm² at 60 %, cut under the fists. Stands square, no brim.

- Deep-cut face — the brow, the eye sockets and the mouth line are cut several millimetres in, not

embossed. They stay readable in a dark filament, which is not true of most monster models this

size.