1 / 4
Gear Skulls — Print-in-Place Keychain, No Assembly — zdjęcie 1
1 / 4

Gear Skulls — Print-in-Place Keychain, No Assembly

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Three skull-faced gears that come off the plate already turning. No assembly, no supports, no pins to push in.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
25
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Standard Digital File License

Three skull-faced gears that come off the plate already turning. No assembly, no supports, no pins

to push in.

Turn the little skull and the whole train moves. It prints flat in one go, 129.6 × 62 mm and only

7.2 mm thick, about 15 g of PLA. The ring at the end takes a keychain split ring.

The photos and the animation are a real print of this file at 100 % scale, orange PLA, straight off

the plate. Nothing was trimmed, reamed or freed with a knife.

What is measured, not guessed

- Ten separate bodies in one file — three gears, the frame with the ring, three axles and three

retaining collars — all closed, all in their final positions. Zero open edges, zero non-manifold

edges, 23 738 triangles. Bambu Studio reported nothing to repair.

- Gears are 62, 31.8 and 17 mm across and 5 mm thick. The train steps down about 3.6 : 1 from the

small skull to the big one, so one full turn of the little gear moves the big face a bit over a

quarter turn.

- Every clearance is in the file, measured on the mesh: 0.32 mm between each gear and its retaining

collar, 1.02 mm between gear and frame, 1.25 mm radial around each axle, 0.14 mm at the tooth mesh.

On a 0.4 nozzle at 0.2 mm layers, that is the gap that decides whether it turns — and it does,

first try, no break-in.

- It lies flat. 3 443 mm² of plate contact, 7.2 mm tall. There is no overhang on this model that is

not either on the plate or a 0.32 mm bridge.

- Filament: about 15 g at 2 walls and 5 % infill — estimated from the geometry, not read off the

slicer.

Tagi