VW 02A/J/K/T Gearbox Digital VSS and Bowden Drive - Useful for engine swaps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Transforms your VW 191.919.149 D Hall sensor into electrical + mechanical at the same time
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
With this easy print you can modify your 191.919.149 D Hall sensor into electrical AND mechanical at the same time. Useful when doing an engine swap into an older car with a bowden driven speedometer, while keeping the electrical wiring with the VSS signal for your ECU.
Disassembly the sensor, drill the top of the sensor out with a 6 mm drill bit, and use epoxy to glue together the parts (shown as blue on the last picture where to put glue). Apply grease on the inside, and its good to go!
The top printed thread is the same as the one on the bottom of the sensor, so you can use the cables that are compatible with the base gear drive.
I recommend using PETG as a minimum, PLA won't do the job here.
I created this easy fix for my TDI swapped VW Golf Mk2, and works perfectly since, paired with the Mk2 1.3 speedo cable and the stock Mk2 dash.
If you have any problems, please feel free to write a comment!
