12 modeli
I designed this weapon for some Cosplayers. Never printed this Thing, maybe you can give me some Infos after you print this sweet thing. Update 1 on Request cut the pieces one by one so you can add this easier into the slicer software!…
2 Year Update! I've been traveling in my camper van full-time using this aeropress station on the roughest roads from the tip of Baja to the Arctic Ocean! This print has held up, keeps things from flying out and keeps all the rattles and…
My own (smaller) version of the Versatile Stackable Storage System
Print vertically with both mounting tabs located on the bottom. Use bolts and nuts to fix on the barrel. If needed use some duct tape on the barrel to add friction.
VSS/AS VAL NPO AEG handguard 3 or more walls, 50% infill
Airsoft adaptor to allow use of odin speedloader for AS val / VSS magazines
A battery cover for an old Yamaha sampling keyboard I have. The original cover was lost years ago, but this one fits fine. Make sure to remove the small supports under the two clips. Print instructions Print Settings Printer Brand:…
This model is designed for a mechanical cable with a slight press fit and a notch to retain the original rubber dust shield. The cable is secured using a cotter pin, which locks behind an inset in the OE cable. To use the bracket: Remove…
Designed and built by the Vikram Space and Science Club (VSSC) . This custom flight simulator console features a functional dual-lever throttle and flaps system powered by precise Hall effect sensors. It also integrates three dedicated…
With this easy print you can modify your 191.919.149 D Hall sensor into electrical AND mechanical at the same time. Useful when doing an engine swap into an older car with a bowden driven speedometer, while keeping the electrical wiring…
100% Infill for Clip & Lock 30-50% infill on Extender & reorient Extender to be Flat/Top shelf side down.
