Centauri Carbon Exhaust Downward 100mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Exhaust vent for Centauri Carbon with downward facing 100mm/4" compatible duct.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print with supports (I used tree supports) as shown in the photo.
There is an issue with the original model, which is that the screws already in the back of the Centauri Carbon cannot be reused to secure this exhaust vent. On my printer, these screws only had 3mm shafts. With the added thickness of the exhaust vent, that 3mm was not long enough to thread back in to the printer. I had to get new fasteners to put the vent on. What worked for me was three M3x10mm with .5 thread pitch.
Another issue is that turning the vent resulted in one of the screw holes being difficult to access. I was still able to screw in the screw, but the model is somewhat in the way of itself.