Rokenbok Barrel Chutes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Chutes, but barrel flavored
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Rokenbok barrel chutes (more to come).
I've always wanted some better ways to incorporate barrels into my builds, I felt like the only good set for that was the recycling center and usually barrels don't go far from where they start. My goal is to make chutes for barrels just like what is available for red and blue Roks (that will be a work in progress and I'll add different chutes as I make them).
Chutes fit regular sized barrels and the XL barrels found here:
All of my test prints have been in PLA Basic and PLA Tough+ and I had no issues as long as I printed the chutes standing up (shown in photo) printing them flat made them weaker where the bottom and sides meet and sometimes started to crack there after several snaps.
New models will be added to this page in the future, Any exsiting models that are changed will updated to v2.