JBL Xtreme 3 - Snapit Racktime 1.0 Adaptor-plate

I just got a new bike and wanted a PROPER Music Solution. So i decided to adapt the JBL Xtreme 3 to my new bike. Among multiple options i went for a modular solution that i can add and remove conveniently at any time. Charging Port is accessible!

So this part helps you to just SnapIt to your compatible "Racktime Snapit (1.0)" System Carrier.

If you have a big printer, you can print it in one piece, if you have something smaller like an Anycubic i3 you can use the 2-piece version, just glue it together.

ADDITIONAL MATERIAL:

• 1 Snapit Adapter (https://www.racktime.com/en/racktime-products/system-accessories/racktime-product/snapit-adapter-1)
• 2x Velcro Strap 60cm I used those: https://www.amazon.de/gp/product/B07W55M75L/
• dont forget the attached washers, they fit better

Printing:

Use Medium Infill for the Plate, there is a small overhang that you can see on the underside, it should print pretty easily without support, just clean it out a bit after printing.

I recommend maximum strength/infill on the washers.

I used CarbonFiber reinforced PLA from Sunlu, you should be fine with any material. If you use the seperated version, just glue them, together.

Then just bolt it to your Racktime baseplate and fit your velcro straps to it.

Enjoy! I would appreciate your MAKES and comment.

Print Settings

Printer:

Anycubic I3 Mega S

Rafts:

Supports:

Resolution:

Infill:

Filament: Sunlu PLA + CF CF reinforced PLA

Category: Sport & Outdoors