Ord Bot Hadron BLTouch Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount that I created to attach the BLTouch probing sensor to my Ord Bot Hadron with Bulldog XL extruder and…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 93
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a mount that I created to attach the BLTouch probing sensor to my Ord Bot Hadron with Bulldog XL extruder and E3D V6 hot end. It attaches to the back side of the X-Carriage using M2.5 screws through the standard mounting holes on the back side of the plate. The BLTouch probe works great and was very easy to set-up connecting to RAMBo board's MX1 header and Z-min endstop.
Post-Printing
Clean up holes and mount BLTouch with wires facing away from X-Carriage. Route wires across the top and through mounting bracket to go underneath X-Carriage plate and back up through large hole on the bottom side of the plate.
Video
A little video demo off the BLTouch in Action on my Ord Bot Hadron Mount.
Category: 3D Printer Accessories