1 / 4
STLINK-V3 MINIE Case with Solderless Dupont Adapter — zdjęcie 1
1 / 4

STLINK-V3 MINIE Case with Solderless Dupont Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A two-part case for the ST-Link V3 MINIE (MB1762) debug probe that also works as a solderless adapter.

Ocena
0 / 5
Polubienia
6
Pobrania
20
Wydruki
0
Wyświetlenia
201
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

A two-part case for the ST-Link V3 MINIE (MB1762) debug probe that also works as a solderless adapter: it connects the probe's card-edge pads (CN2) directly to standard male Dupont jumper wires. No soldering, no special connector needed – just plug the other ends into a breadboard or your target board and you can program/debug over SWD, JTAG or use the Virtual COM port.

How it works: the CN2 card-edge pads (5 on top, 5 on bottom, 2.0 mm pitch) are pressed against the pins of ordinary Dupont jumpers. Each half of the case has open channels that guide the metal pins onto the gold pads and wedge them there with light pressure, while the trapezoid grooves hold the plastic Dupont housings so they can't fall out. You see every pin during assembly, so contact is easy to verify.

Features

  • Opening for the STDC14 (CN4) connector – the original flat cable still works without opening the case

  • USB-C opening, window above the COM LED

  • Board orientation is enforced by the geometry – it can't be assembled the wrong way

  • Closed with 4 slide-on external clips (printed, replaceable); 4× M3 screw holes as optional backup

  • Pin numbers engraved next to the Dupont slots (numbering follows ST's UM2910, Table 3: 1 reserved, 2 TDI, 3 SWDIO, 4 SWCLK, 5 SWO / 6 GND, 7 VCP-RX, 8 VCP-TX, 9 NRST, 10 VCC)

Printing: all parts print without supports. Halves flat with the parting face up, 0.10–0.12 mm layers recommended (the pin channels are small). Clips as oriented in the STL, print 4 pcs, 3+ perimeters, PETG recommended for the clips. PLA works for the case.

Assembly: snap Dupont wires 6–10 into the bottom half, lay the board in (USB-C towards the end opening), snap wires 1–5 into the top half, close, slide the clips on. Done.

Tagi