Fuxtec Replacement Joint
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement joint for a Fuxtec handcart. The joint broke on my handcart and I replaced it with 2 pieces of this item.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I replaced the original rivet with an M6 screw and nut. Do not tighten too hard as the parts should move. Usage of a locknut is recommended.
Versions
Fuxtec Connectorhas the thickest jointFuxtec Connector Slimhas an 0.4mm thinner jointFuxtec Connector Extraslimhas an 1mm thinner joint (than the thickest)Make your own: If none of the above fit into your tubes, I provided a STEP-file so you can adjust as you like.
Print settings
Material: I first printed in PLA to test which version of the connector fits in the steel tube. On my handcart both tubes were differently sized. I intended to switch to PETG later, but currently the PLA holds.
Supports: Supports on baseplate
**Infill:** 70% Gyroid