1 / 2
Tension Rod Door Bracket — zdjęcie 1
1 / 2

Tension Rod Door Bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tension Rod Door Bracket that fits a majority of screen doors with multiple mounting holes.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
10
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This mounting bracket works for a majority of doors and acts as a cheap, viable replacement for a bent aluminum bracket that no longer functions. 

It features several holes that are modeled at 5.8mm in diameter but after plastic expansion during printing end up around 5.6-5.7mm. They use basic self tapping screws less than about an inch in length that you can find at any hardware store. 

The orginal versions use a shaft/pin with a c-clip or cotter pin to secure the tension rod and allow it to pivot but I found that using a bolt and nut was perfectly fine and actually secured it better. I used an M3x20m Bolt with an M3 Nut and i added a tiny bit of wd-40 for lubrication but graphite would work fine as well. 

It would likely be fine to print the bracet with 5-7 walls and 15% gyroid infill however I opted for 7 walls with 100% infill just because I didn't mind spending a few extra cents on the filament. You also CAN print it WITHOUT supports but since the hole safgs and ovals out slightly I added supports with a PLA interface 

Tagi