EXV or EEV Valve Actuator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a manual valve actuator for EXV or EEV or Electronic Expansion Valves.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Intro
This is a manual valve actuator for some types of EXV's or EEV's. I found the official ones to be expensive and overtime the magnets can come loose. This model will encapsulate the magnets to prevent that. I created two models; one with a keyring slot and one without. So far I have only tested it on Carel EEV's used in Heatcraft evaporators.
Assembly
The trick is the six magnets need to have the north polarity facing out. Then add a pause at layer "111" and add a little superglue to each magnet when inserting. The superglue is to prevent the magnets from adhering to steel/hardened nozzles when printing is resumed.
The magnet polarity can be verified with a compass and Clough42 has a good video on how to determine polarity, linked below.
Parts
This model will needs six magnets size 12x5x3mm. Amazon Non-Affiliate Link https://www.amazon.com/dp/B09Y5VNPPG
The key ring size is 16mm. Amazon Non-Affiliate Link https://www.amazon.com/dp/B07TMNPQ9S
Print Settings
Recommended PETG Filament
0.2mm Structural in PrusaSlicer
No Supports
Used Prusament PETG Signal White in the Photo