Extruder relocation mount for Creality printers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Relocates the extruder on Creality Ender 2 pro, 3, 3 pro, 3V2, 3 max and CR-6, CR-10 printers for a better filament path
- Ocena
- 5 / 5
- Polubienia
- 73
- Pobrania
- 430
- Wydruki
- 8
- Wyświetlenia
- 3246
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is an updated version V1.2
Previous V1.1: https://www.thingiverse.com/thing:4820250
V1.2 fixes:
Larger holes for easier screw insertion,
Now compatible with camera mounting solutions like these:
https://www.thingiverse.com/thing:2886101
https://www.thingiverse.com/thing:3294512
https://www.thingiverse.com/thing:4721088
Original mounting place for the extruder motor on Ender style printers bends the bowden tube in a shape, that makes it spin inside the teethed couplers, chewing through the ptfe and making it lose grip. This mount rotates the feeder output to the same direction as the hot end, thus removing torque on the bowden tube. On my ender 3v2 there was just enough wire length to comfortably reach all limits of the printer, but a longer tube was needed. There is a chance you might need to extend the wires for your autolevel sensor. I used jumper wires for that.
To install this mod replace the X axis limit switch cover with this one and screw it on with original screws. To route your wires like mine, you'll need to take off the motherboard cover and striaghten all the bunched up wires that go to the hotend carriage. Face the feeder motor connector towards the back. Cut your ptfe tube to 55-60cm in length. Move the original spool mount to the back left side or the front left side, bolt it on with it's T-nuts through the side holes and feed filament in from the bottom side.
For cable management, cable_1 and cable_2 are mounted where feeder motor once was, use zipties in given slots to mount cables and add some wire or a piece of filament for the hinge. I made a notch and a hole in the left back side 4040 extrusion cover and ziptied the cable loom to it for stability. For 3D touch wires I used standard Arduino type cables with dupont connectors to extend them.
I advise to print this from a higher temperature resistance filaments than PLA because of the stepper motor getting hot and screws loosening over time even though PLA worked for me well untill I replaced it with PETG.
Disclaimer: you do need a slightly longer ptfe tube than original and some zip ties will be handy.
Left side screen mount visible in the photos: https://www.printables.com/model/183795-ender-3-v2-adjustable-left-side-screen-mount
Feel free to purchase a printed version of this bracket from this affiliated etsy store: https://www.etsy.com/ca/ScentsiblePrints/listing/1197169435/task-mount-creality-ender-series-3d