1 / 4
Vertical Hopper Chute Remix for the Filastruder v2.0 — zdjęcie 1
1 / 4

Vertical Hopper Chute Remix for the Filastruder v2.0

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I redesign the chute used on the Vertical hopper so it can be used on the Version 2.0 filastruder. Plus I also design…

Ocena
0 / 5
Polubienia
2
Pobrania
13
Wydruki
0
Wyświetlenia
154
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I redesign the chute used on the Vertical hopper so it can be used on the Version 2.0 filastruder.

Plus I also design a vibration mechanism for the chute to solve feed issues, the vibrator is a little too powerful so I need to seal the desiccant hole up with tape otherwise it shakes the pellets out.

These are the parts needed for the vibrator you can get them from Jaycar if you live in Australia.

https://www.jaycar.com.au/standard-high-power-d-c-motors-20000-rpm/p/YM2772 12V DC motor

https://www.jaycar.com.au/timer-progr-interval-module-12v/p/AA0378 Timer module, (a relay is needed as the timer can only handle 5Amps but a 30A horn relay will work for the switching as the motor has a high current draw)

https://www.jaycar.com.au/automotive-fused-relay-spst-30a/p/SY4077 The horn relay to drive the motor.

You will need to use a 12V supply that can provide approx 14A as this is what the motor needs, (I kinda made the vibration mechanism a tad too powerful)

Category: 3D Printer Extruders

Tagi