Garmin EchoMap DV Fish Finder Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount replacement for a Garmin EchoMap DV Fish Finder
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Ever had a stump chase you down just to post up in front of you to break the little mount that holds your precious fish finder in the water?
Yeah, well my buddy did and needed a replacement. Only to find out Garmin doesn't make or sell these individually to the public. 3D printing to the rescue!
I made two versions of the original mount: one with the tabs as designed, and one with the center piece solid. As an engineer, I would NOT recommend the piece being solid in the center. Should a stump run you down again, you want the part that breaks to be the easiest and cheapest part of the setup. I'll post both versions though, use at your own risk.
I highly recommend using ASA for this project as it is plenty strong for this purpose and it has UV resistant properties. If not ASA, use PETG.
In the model, I used a modifier in place that forces everything from the base upwards to be printed with 99 walls, essentially meaning the mounting ears (or solid piece) is 100% plastic in these areas. It will add a lot of strength to the weakest point of this print.
Let me know what you think!