no fluff double-decker guitar stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
single piece, low support stand for two electric guitars
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
I couldn't find any stand for two guitars that I could set up for print in the morning on a 25cm long print bed and have it ready the same day with no assembly. So I made one.
The sides are inset on both sides to give it that structurally strong H-bar shape and reduce the filament needed additionally it's meant to be printed with "make overhangs printable" turned on. The model is quite light so I recommend not using only the top rack as it might tip, additionally it probably works best with asymmetric guitars due to how it holds them at an angle. I also suggest using a bit of felt or other soft fabric in the grooves to avoid any scratches and maybe rubber pads on the bottom.
This model was printed on anycubic kobra s1 in slightly under 12h with 7% adaptive cubic infill, 0.26 layer height and 3 perimeters with cooling only on overhangs and one tree support on the front embellishment.