1 / 5
Narwhistle — narwhal whistle, loud twin-chamber, one piece, no supports — zdjęcie 1
1 / 5

Narwhistle — narwhal whistle, loud twin-chamber, one piece, no supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A narwhal that is a loud twin-chamber whistle: blow the tusk, sound from the blowhole. One piece, no supports.

Ocena
0 / 5
Polubienia
1
Pobrania
7
Wydruki
0
Wyświetlenia
37
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Narwhistle

A narwhal standing on its flukes on an ice floe — and a loud pealess whistle. Blow into the tip of the tusk; the sound comes out of the blowhole on the back of its neck. One piece, print-in-place, no supports, no glue and no hardware.

Hear it

the narwhistle, and what it sounds like

https://youtu.be/xWAwDLZRavQ

The clip is silent for its first two seconds on purpose — set your volume before it starts, and be ready to drop it again.

What it sounds like

These numbers are measured off a recording of the printed part, not predicted from the drawing:

  • a 2266 Hz carrier — right in the band human hearing is most sensitive to

  • partials 8.8 dB down at 2208 and 2332 Hz, which is the two chambers pulsing against one another, so the note warbles about 66 times a second instead of sitting flat

  • harmonics at 4694 Hz and 7039 Hz

A steady tone is easy to mistake for machinery. A warbling one is not, which is the whole reason a rescue whistle beats shouting.

How it works

Behind the tusk is a plenum, and behind that two stopped-pipe chambers of slightly different length sharing one windway, split by a 1.2 mm centre deflector. That is the Fox 40 layout — the architecture the printed whistles that win side-by-side loudness tests all share, and the reason there is no pea. A pea only adds a warble and a way to clog; two chambers give you the warble for free and nothing can rattle loose inside.

Every acoustic surface is a vertical wall in the print pose: both 1 mm windway slots, the septum, the chamber walls and the labium edge. That is why it needs no supports and why the edge comes out sharp — a whistle goes silent when its labium prints as a layered overhang.

Printing

Print exactly as exported: floe on the bed, tusk straight up. 0.4 mm nozzle, 0.2 mm layers, 3 walls, 15 % infill, supports OFF, a 3–5 mm brim. PLA.

Put the Z-seam on the belly side — the side without the blowhole slots. A seam blob inside a 1 mm windway is the one thing that can mute it.

Please read this bit

This is not an indoor toy. It is as loud as the referee whistle it is modelled on, and small children put whistles directly against their own ears. Lanyard hole goes through the ice floe.

102 × 40 × 31 mm · one piece · ~12 g at 15 % infill · about 1 h 15.

Tagi