Cocoa Press 1.0 to 2.1 Upgrade Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printable parts for upgrading Cocoa Press 1.0 directly to 2.1, organized by upgrade-manual chapter.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 22
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are the 3D printable parts for upgrading a Cocoa Press 1.0 directly to Cocoa Press 2.1.
Assembly instructions: Cocoa Press 1.0 to 2.1 Upgrade Manual and kit resources.
Files and folders follow the chapters in the 1.0 to 2.1 upgrade manual. The C-number is the chapter number; an a after it identifies an accent-color part. Use Cocoa Press red for primary parts and Cocoa Press brown for accent parts.
Chapter 2 - Disassembly: 2 files
Chapter 3 - Hermit Crab: 2 files
Chapter 5 - Build The Extruder: 6 files
Chapter 6 - Electronics: 7 files
Chapter 7 - Screen: 6 files
Print quantities: Print two Belt Clips (C3a-Belt_Clip_x2), three Zip Tie Anchors (C7a-Zip_Tie_Anchor_x3), and one of every other part. The Power Inlet Bracket is optional if you retain the existing bracket.
C6-Lower_Center_Cover_Panel is the Cocoa Press 2.0 version specified for this upgrade. C7-Rear_Left_Base_rev2 is a new revision of the rear left foot. The file might not look exactly the same as the manual.
Suggested print settings: PETG; 0.2 mm layer height; 0.4 mm nozzle; 3 walls; 25% grid infill; 4 bottom solid layers; 5 top solid layers. Follow the manual for part orientation and assembly.