Ersatzbrücke für alten Hailo Dreifach-Mülleimer / Replacement Bridge for old Hailo tripple bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Wstępna wycena dla PETG
0,76 € – 0,93 € netto (bez VAT)
Dla pliku: Replacement_ Bridge_for_Hailo_Bin_B_0.4n_0.2mm_PETG_COREONE_44m.bgcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 0,85 € netto (środek widełek).
- Masa podana przez autora
- 14 g
- Czas druku podany przez autora
- 43,8 min
- Materiał u źródła
- PET
- Materiał wyceny
- PETG
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
Ersatzbrücke zur Aufnahme des mittleren Eimers bei einem älteren Modell eines dreifach Hailo-Mülleimer.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 11
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Einer meiner ersten Versuche ... / One of my first tries ...
Bei unserem alten Hailo-Dreifach Mülleimer brach die Brücke auf einer Seite, in welchen der mittlere Eimer eingehängt ist. Habe die Brücke entfernt, so dass an jeder Seite noch ein kleiner Stummel (5 mm und 10 mm) übrig war und die Ersatzbrücke dort eingesteckt und damit etwas verankert werden konnte.
Bitte vor Druck die Abmessungen prüfen. Beim Einstecken muss die eine Seite (5 mm Stummel) des Plastikrandes ein wenig nach außen gedrückt werden um die Brücke "einzurasten".
Gedruckt mit PETG auf einem Core One+. Erstellt mit OpenSCAD.
On our old Hailo triple bin, the bridge on one side broke, where the middle bin is hooked in. I removed the bridge, leaving a small stub (5 mm and 10 mm) on each side so that the replacement bridge could be inserted there and thus could be anchored a little.
When inserting it, you need to push one side (the 5-mm stub) of the plastic edge slightly outward to "snap" the bridge into place. Please check the dimensions before printing.
Printed with PETG on a Core One+. Made with OpenSCAD.