MPCNC Lowrider 2 Junk Bumper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A dust "bumper" for the MPCNC Lowrider 2 by V1 Engineering designed it to keep low-flying chips away from the lead screw
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 232
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
Description:
This is a dust "bumper" for the MPCNC Lowrider 2 by V1 Engineering. I designed it to keep most of the low-flying chips and dust from ending up in my Z axis lead screw and bearings. It will also plow dust and chips away from the movement of the wheels.
Printed Parts:
You will need 2 sets of each printable part per side. PLA or PETG would work. A high infill and/or wall count would be preferable for the washer and bushing.
Panel:
The panel floats on the bushing so that it can move freely and will not jam or obstruct any movement on the Y axis while staying flat on the table. I used 1/2" PVC and made 1/4" pockets for the bushings. Any material will do as long as the pockets leave 1/4" remaining material thickness or less. Drill holes for the screws using the corner brackets as guides.
Assembly:
The wheel washer is installed with the ridge facing towards the wheel to make contact with the bearing. The panel goes on next followed by the bushing and nut. The bolt should be long enough. If the wheel does not rotate after installation the nut is too tight. Back it off until the wheel move freely.
M4 screws and nuts are used to hold the corners on. Any screw/combo size would work and the position of the holes keeps the screws away from the wheels.
Enjoy!
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.28
Filament:
Polymaker PLA or PETG
Category: Parts