Ghostbusters Containment Unit Red Knob (Dakaware 3/4" knob)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printable replica of the rare Dakaware 3/4" red knob used on the Ghostbusters Ecto Containment Unit
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Details
3D printable replica of the rare Dakaware 3/4" red knob used on the Ghostbusters Ecto Containment Unit
This is designed to fit snugly over a standard 6mm potentiometer/switch shaft
It has a side hole for a M2.5 grubscrew (optional)
The reference knob has a white pointer but this isn't present in the film, so I have excluded that from this design
There are two variants available, both with and without clearance underneath. Without clearance is easier to print as it doesn't require supports, but the clearance could be useful if you're installing onto a potentiometer shaft with a hex nut on the front.
If printing with FDM, use a low layer height (or variable layer height) to smooth out the curved top surface as much as possible before sanding/painting
Special Thanks
910dohead from the Southland Ghostbusters for identifying the Dakaware knob and providing clear photographs: https://forum.gbfans.com/t/containment-unit-discussion-build/24041/90
tobycj from the East Midlands Ghostbusters for sending measurements of a genuine knob for me to base this file off