1 / 7
Battery case 18650 with room for charger and step-up converter — zdjęcie 1
1 / 7

Battery case 18650 with room for charger and step-up converter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A battery case for 18650 Lipos with room for a perfboard 80x20 mm (e.g. to house both a charge circuit and a step-up…

Ocena
0 / 5
Polubienia
11
Pobrania
50
Wydruki
0
Wyświetlenia
547
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

A battery case for 18650 Lipos with room for a perfboard 80x20 mm (e.g. to house both a charge circuit and a step-up converter). Cutout for a 12x19 mm switch to separate the (+) output of the charger/protector from the input of the step-up converter.

Parts used:

  • Perfboard 80x20 mm
  • USB LiPo Charger/Protector TP 4056 (board version with integrated output overload/undervoltage cutoff)
  • Step-Up Converter MT 3608.
  • On/Off switch snap-in for cutout 19x12 mm, 250V / 3A, height beneath front panel 19mm.

Assembly:

  • both boards soldered with 0,7 wire as stand-off onto the perfboard.
  • use the battery terminals of the TP4056 board as contact points
  • use some loops of uncoated copper wire around the plastic springs for the battery terminals.
  • use isolated wire to connect the loops to the battery terminals of the TP4056
  • connect ground/minus directly between TP4056 output pad and MT3608 input pad
  • connect plus through the on-off switch. Can be made with 6.35 mm crimp connectors if you cut off the crimp part and solder the wires along the cut line.

Print Settings

Printer:

TronXY X5S

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

0.6 mm nozzle, 0.25 mm layer height

Infill:

15%

Filament:

Generic budget PLA

gray transparent

Category: Electronics

Tagi